2V0-41.24 Question 319
Single answerYou are configuring an NSX-T Data Center environment for a multi-tenant setup. The physical infrastructure has been prepared with three VLANs dedicated to tenant traffic, and you need to create uplink segments in NSX-T to map these VLANs. Which action is required during the creation of an uplink segment?
- A
Specify the VLAN ID associated with the uplink segment
- B
Assign a Transport Node Profile to the uplink segment
- C
Enable DHCP Relay on the uplink segment
- D
Attach the uplink segment to an Edge Cluster
Show answer and explanation
Correct answer: A
Explanation
Uplink segments in NSX-T are used to connect the overlay network to the physical network. During their creation, you must specify the VLAN ID to ensure the uplink segment is properly mapped to its corresponding VLAN on the physical network. This is a critical step in enabling tenant communication through the specified VLANs.
- A. Correct.
Correct. When creating an uplink segment, specifying the VLAN ID is mandatory to map the segment to the appropriate VLAN on the physical infrastructure.
- B. Incorrect.
Incorrect. Transport Node Profiles are not directly assigned to uplink segments; they are associated with Transport Nodes instead.
- C. Incorrect.
Incorrect. DHCP Relay is not configured on uplink segments; it is typically configured at the logical switch or gateway level.
- D. Incorrect.
Incorrect. Uplink segments are not attached to Edge Clusters. Instead, they are mapped to physical NICs via Transport Nodes.