2V0-41.24 exam dumps

2V0-41.24 practice question 337 of 462

VMware Certified Professional - Network Virtualization 2024. Associate level, VMware. Free question with the correct answer and a full explanation.

2V0-41.24 Question 337

Select 3

A network administrator is tasked with creating a Tier-0 gateway in an NSX-T environment to provide north-south connectivity for virtual workloads. The administrator wants the Tier-0 gateway to support high availability and dynamic routing with a physical router. Which steps must the administrator take to properly configure the Tier-0 gateway?

  1. A

    Select 'Active-Active' as the High Availability mode for the Tier-0 gateway.

  2. B

    Configure BGP on the Tier-0 gateway for dynamic routing.

  3. C

    Assign an external interface to the Tier-0 gateway and configure an IP address.

  4. D

    Enable NAT on the Tier-0 gateway to route traffic between external and internal networks.

  5. E

    Connect the Tier-0 gateway to a Tier-1 gateway in the environment.

Show answer and explanation

Correct answers: B, C, E

Explanation

To create a Tier-0 gateway that supports high availability and dynamic routing, the administrator must configure BGP for dynamic routing, assign an external interface with an IP address for external connectivity, and connect the Tier-0 gateway to a Tier-1 gateway. High Availability mode should be chosen based on the use case, and NAT is not typically required at the Tier-0 level unless specific use cases demand it.

  • A. Incorrect.

    Incorrect. 'Active-Active' High Availability mode is only necessary when you need to distribute traffic across multiple edge nodes. For most scenarios requiring high availability, 'Active-Standby' is recommended.

  • B. Correct.

    Correct. BGP must be configured on the Tier-0 gateway to enable dynamic routing with external physical routers.

  • C. Correct.

    Correct. Assigning an external interface with an IP address is necessary to establish connectivity between the Tier-0 gateway and the external network.

  • D. Incorrect.

    Incorrect. NAT is not required for Tier-0 gateways when they are only used for routing; NAT is typically configured at the Tier-1 level.

  • E. Correct.

    Correct. A Tier-0 gateway must be connected to a Tier-1 gateway to route traffic between internal workloads and the north-south external network.

Timed practice exam

Take a 2V0-41.24 practice test under exam conditions

55 questions in 135 minutes, drawn from this bank, with a score report and a per-question review when you finish.

Start timed exam

More 2V0-41.24 practice questions

  1. 338.You are tasked with creating a Tier-0 gateway in an NSX-T Data Center to connect your data center...
  2. 339.You are tasked with connecting a Tier-0 (T0) gateway to a Tier-1 (T1) gateway in an NSX-T Data...
  3. 340.An administrator is configuring a VMware NSX environment and needs to establish communication...
  4. 341.An administrator is tasked with connecting a Tier-0 gateway to a Tier-1 gateway in an NSX-T Data...
  5. 342.An organization has deployed NSX-T Data Center with a Tier-0 gateway configured to provide external...
Back to the 2V0-41.24 exam dumps